FRP Grating vs Steel Grating: Which Is Better for Industrial Flooring?

Walkways, platforms and trench covers take a beating, especially in chemical plants, treatment plants and coastal sites. For decades galvanised steel was the default. Today more engineers specify FRP (fibre-reinforced polymer) grating instead. Here is how the two compare, and when each makes sense.

Quick comparison

FactorFRP gratingSteel grating
CorrosionDoes not rust. Resin can be matched to specific chemicalsRusts once galvanising is damaged. Needs repainting
WeightRoughly a quarter of steel for a similar panelHeavy, often needs lifting equipment
ElectricalNon-conductive, non-magneticConductive
Slip resistanceGritted or concave surface built inSerrated bars available, slippery when oily
InstallationCut with standard tools, no hot workCutting and welding usually needed
Initial costOften similar or higherOften lower
Lifetime costLow, with minimal maintenanceHigher in corrosive areas because of upkeep and replacement
High heat / fireUse fire-retardant resin. Not for very high temperaturesBetter at very high temperatures

Where FRP grating wins

Corrosive environments. In effluent treatment plants, electroplating shops, fertiliser units and marine structures, steel grating can corrode within a few years. FRP made with the right resin (isophthalic polyester for general use, vinyl ester for aggressive chemicals) keeps its strength and appearance.

Electrical safety. Because FRP does not conduct electricity, it is widely used around substations, battery rooms and cable trenches.

Fast, safe installation. Light panels can be carried by two people and cut on site with a circular saw, with no welding permits or cranes needed in most cases.

Where steel may still be the better choice

Steel remains a sensible choice for areas with very high temperatures, heavy point loads from vehicles over long spans, or where a project is short-term and initial cost matters more than lifetime cost.

Moulded vs pultruded FRP grating

Moulded grating is made in a single piece with fibres running in both directions. It has a square mesh, equal strength both ways and excellent corrosion resistance, which makes it the most common choice for walkways and trench covers. Pultruded grating has load bars in one direction and is stiffer over longer spans, so it suits platforms where deflection is critical.

How to specify FRP grating

  • Span and load: the clear span between supports and the expected load (pedestrian, trolley or light vehicle)
  • Environment: the chemicals present, temperature and UV exposure, which decide the resin
  • Thickness and mesh: common thicknesses are 25 to 50 mm. Smaller mesh suits footwear-heavy areas
  • Surface: gritted for oily or wet floors
  • Colour: grey for general use, yellow for safety zones

Falcons Fiber manufactures FRP gratings in Navi Mumbai in standard and custom sizes. See our gratings or send us your span and load for a recommendation.

Leave a Reply

Your email address will not be published. Required fields are marked *

WhatsApp
Phone