Walkways, platforms and trench covers take a beating, especially in chemical plants, treatment plants and coastal sites. For decades galvanised steel was the default. Today more engineers specify FRP (fibre-reinforced polymer) grating instead. Here is how the two compare, and when each makes sense.
| Factor | FRP grating | Steel grating |
|---|---|---|
| Corrosion | Does not rust. Resin can be matched to specific chemicals | Rusts once galvanising is damaged. Needs repainting |
| Weight | Roughly a quarter of steel for a similar panel | Heavy, often needs lifting equipment |
| Electrical | Non-conductive, non-magnetic | Conductive |
| Slip resistance | Gritted or concave surface built in | Serrated bars available, slippery when oily |
| Installation | Cut with standard tools, no hot work | Cutting and welding usually needed |
| Initial cost | Often similar or higher | Often lower |
| Lifetime cost | Low, with minimal maintenance | Higher in corrosive areas because of upkeep and replacement |
| High heat / fire | Use fire-retardant resin. Not for very high temperatures | Better at very high temperatures |
Corrosive environments. In effluent treatment plants, electroplating shops, fertiliser units and marine structures, steel grating can corrode within a few years. FRP made with the right resin (isophthalic polyester for general use, vinyl ester for aggressive chemicals) keeps its strength and appearance.
Electrical safety. Because FRP does not conduct electricity, it is widely used around substations, battery rooms and cable trenches.
Fast, safe installation. Light panels can be carried by two people and cut on site with a circular saw, with no welding permits or cranes needed in most cases.
Steel remains a sensible choice for areas with very high temperatures, heavy point loads from vehicles over long spans, or where a project is short-term and initial cost matters more than lifetime cost.
Moulded grating is made in a single piece with fibres running in both directions. It has a square mesh, equal strength both ways and excellent corrosion resistance, which makes it the most common choice for walkways and trench covers. Pultruded grating has load bars in one direction and is stiffer over longer spans, so it suits platforms where deflection is critical.
Falcons Fiber manufactures FRP gratings in Navi Mumbai in standard and custom sizes. See our gratings or send us your span and load for a recommendation.





